Session aimPulses (with plasma) to test chopper integrators
Session day2025-07-23Operatorrhenriques
Session IDISTTOK_20250723_1Coordinatorrhenriques

Shot Time Operator Iplasma(kA) n(1018m-3) Duration (ms) Pre/post shot comments
532292025-07-23 14:09:46.636rhenriques1226Repeat with connection to MARTe2 ATCA removed to lower the load to the diagnostic | Same thing again, must be RT3ch14 that is not working properly
532282025-07-23 13:59:05.916rhenriques1226Repeat with IPLB in RT3ch14 (as ch13 is not working) and RT3ch15 | IPLB signal too small resulted in saturation detection
532272025-07-23 13:45:50.759rhenriques-4.4026Repeat with IPLB connected to chopper modules | 3.2 kA at flattop
532262025-07-23 13:39:50.914rhenriques-4.5026Repeat with 53222 with RT3ch15 modified to have G=1 (still w/o capacitors -> no filtering) | Forgot to connect IPLB to chopper modules, Ip flattop at 3.2 kA
532252025-07-23 10:23:43.639rhenriques-4.44.426Repeat with IPLB conected to B3ch29 and analog integrator only | OK, Ip flattop around 3 kA
532242025-07-23 10:15:10.511rhenriques1626Repeat after reloading MARTe configuration, pulse detected several saturations | IPLB signal is much lower than it should, hence saturation detections and short pulse duration
532232025-07-23 10:05:02.52rhenriques1226Repeat with IPLB also acquired in B3ch29 (2MSps) to check if ADC saturates | Pulse did not run as expected, configuration needs to be checked
532222025-07-23 09:26:35.964rhenriques-4.14.2526Repeat (1) 53101 to assess max Ip and wall conditioning and to test IPLB signal in RT3ch13 (G1), RT3ch15 (G10, module w/o capacitors) and analog integrator | OK, Ip flattop around 2.8 kA
532212025-07-23 09:16:21.819rhenriques000Dryrun (file: dryrun_standard_2025_04_04_52149.cfg), no TF | PF currents OK