Session aimContinue with pulses (with plasma) to test chopper integrators and diagnostics
Session day2025-07-24Operatorrhenriques
Session IDISTTOK_20250724_1Coordinatorrhenriques

Shot Time Operator Iplasma(kA) n(1018m-3) Duration (ms) Pre/post shot comments
532392025-07-24 16:54:30.555rhenriques-4.64.926Repeat with further adjustments on scope setttings | Spikes go to 3.5 V
532382025-07-24 16:49:50.063rhenriques-4.64.7626Repeat with further adjustments on scope setttings | Better, negative spikes go below -2 V
532372025-07-24 16:44:53.459rhenriques-4.53.226Trying again with different scope settings | Better, IPLA signal goes to 1 V at least
532362025-07-24 16:30:13.551rhenriques-4.44.826Repeat test using IPLA signal | Better but still not properly configured
532352025-07-24 16:25:06.155rhenriques1526Repeat 53232, plasma pulse, to check max value of IPLB signal with oscilloscope | teste not successful
532342025-07-24 16:19:25.488rhenriques000Repeat 53232, plasma pulse, to check max value of IPLB signal with oscilloscope | Forgot to load the right MARTe configuration
532332025-07-24 16:01:23.271rhenriques000Dryrun (file: dryrun_standard_2025_04_04_52149.cfg) to test pickup on IPLB and IPLA | OK, good
532322025-07-24 15:44:05.11rhenriques-4.34.526Repeat with IPLA raw signal cable connected to RT3ch10 | Signals are good, Ip at flattop at 3 kA
532312025-07-24 15:20:24.058rhenriques-4.24.326Repeat (1) 53101 to assess max Ip and wall conditioning, IPLB in RT3ch11 and analog integrator and IPLA in RT3ch10 and analog integrator in RT2ch4 | Ip at flattop at 2.8 kA, RT3ch10 no good signal
532302025-07-24 15:08:37.40rhenriques000Dryrun (file: dryrun_standard_2025_04_04_52149.cfg), no TF | PF currents OK, forgot to activate pressurized air system...